Publicité
Les langues disponibles
Les langues disponibles
V1.0
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
STORAGE
Store the press in a dry location with ram and piston fully
retracted when not in use.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
DISPOSAL OF HYDRAULIC FLUID
Do not drain hydraulic oil into the sewer system or dispose in an
uncontrolled location. Hydraulic fluid may take more than a year
to breakdown in the environment and the ingredients may still be
toxic. Contact your local municipality for proper disposal
instructions or locations.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
Problem(s)
Tool runs
slowly. Air
flows slightly
from exhaust.
Visit www.princessauto.com for more information
50 Ton Pneumatic/Hydraulic Shop Press
Possible Cause(s)
1. Motor parts jammed
with dirt particles.
2. Airflow blocked by
dirt.
3. Air regulator in
closed position.
Suggested Solution(s)
1. Check air inlet filter for blockage.
2. Pour air tool lubricating oil into
air inlet as per Lubrication
instructions. Operate tool in
short bursts.
2.1. Repeat above as needed. If
this fails, contact Princess
Auto Ltd. for a solution.
3. Open the air regulator to desired
airflow.
8836371
15
Publicité
