Publicité
Les langues disponibles
Les langues disponibles
8836371
4.1 When an air source is unavailable, pump the handle until
the serrated saddle nears the workpiece.
5.
Align the workpiece and ram to ensure center-loading.
6.
Press down the pedal (or pump the handle) to apply load to
the workpiece.
7.
When the work is done, release the pedal (or stop pumping
the handle). Slowly and carefully remove load from the
workpiece by turning the release valve counterclockwise in
small increments.
8.
Once the ram has fully retracted, remove the workpiece from
the bed frame.
9.
Disconnect the air inlet fitting from the air source when
finished for the day.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool handles clean, dry and free from oil/grease at
all times.
6.
Maintain the tool's labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
12
50 Ton Pneumatic/Hydraulic Shop Press
For technical questions call 1-800-665-8685
V1.0
Publicité
