Télécharger Imprimer la page

PRO-POINT 8836371 Manuel D'utilisateur page 10

Publicité

Les langues disponibles

Les langues disponibles

8836371
8.
Attach the other two small roller assemblies at the bottom
of each post in the same manner as step 7.
9.
Attach the ram assembly (#14) to the upper cross beam
using bolts (#13), flat washers (#15), lock washers (#16) and
nuts (#17).
10. Attach the hand winch (#42) and its base plate (#44) to
the left post using two bolts (#2), flat washers (#5) and
nuts (#7). Connect A to A.
11. Push each bed frame pin (#18) through the same holes on
the left and right posts. The bed frame (#36) will rest on
these, so ensure they are level with each other. Secure
each side with a retaining ring (#39).
12. Position the bed frame so the beams are outside of the
posts. Lower until the platform is resting on the pins.
13. Attached the wire rope (#34) to the right tube bushing
assembly (#37) on the bed frame.
13.1 Wrap the cable over the small roller assembly at the
top of the right post.
13.2 Guide it down and wrap around the outside of the
small roller assembly at the bottom right post.
13.3 Guide the wire rope around the small roller on the
bottom left post and attach to the left tube bushing
assembly on the bed frame.
14. Guide the wire rope from the hand winch over the big
roller assembly on the upper left post and down to the left
tube bushing.
15. Attach the pump assembly (#29) to the right post using
bolts (#20) and washers (#21), then connect the fitting of
the hydraulic hose (#28) tight to the oil inlet fitting (B to B)
at the ram assembly's base (#14). Connect part C to C.
16. Install the pressure gauge (#24) by connecting one end of
the gauge hose (#23) to the pressure gauge, the other end
to the fitting on the base of the ram assembly (#14).
10
50 Ton Pneumatic/Hydraulic Shop Press
For technical questions call 1-800-665-8685
V1.0

Publicité

loading