Publicité
Les langues disponibles
Les langues disponibles
8836371
5.
Check the oil filler hole and, if necessary, top off the oil
filler hole with more hydraulic oil.
6.
Restore the oil filler nut and breather oil plug. Close the
release valve by turning clockwise.
7.
Test the ram several times for proper operation before
putting it into use. Do not use the ram if it still does not
appear to be working properly. Have a qualified service
technician service or repair the hydraulic system.
CLEANING
Clean the outside of the press with a dry, clean and soft cloth.
LUBRICATION
Inspect and lubricate the tool when required. Only use a light oil.
Periodically lubricate the hoist, wheel shaft assembly, the joints
and all moving parts. Do not allow oil onto the heel blocks or
frame of the shop press.
AIR TOOL LUBRICATION
Only use air tool oil to lubricate the air system. Other lubricants
may not be suitable and could damage the tool or cause a
malfunction during use.
1.
Manually add a drop or two of air tool oil into the air valve
before each use, and after every hour of continuous use.
Without lubrication, the tool will not work properly and parts
will wear prematurely.
2.
Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. The tool will need to be
taken apart by a qualified technician and cleaned of excess oil.
3.
In the event that it becomes necessary to store the tool for
an extended period of time (overnight, weekend, etc.), it
should receive a generous amount of lubrication at that time.
The tool should be run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
14
50 Ton Pneumatic/Hydraulic Shop Press
For technical questions call 1-800-665-8685
V1.0
Publicité
