Rothenberger ROBEND 4000 Instructions D'utilisation page 8

1. Technical characteristics
Bending capacity:.............................................. 12 – 35 mm
Bending angle:.................................................. 0º - 180º
Voltage: ............................................................ 230 V 50/60 Hz
Absorbed power: .............................................. 1010 W (900W)
On-switch: ........................................................ Non-blocking
Machine weight: ............................................... 13 kg.
Machine dimensions: ........................................ 590 x 145 x 215
Complete set weight (12,15,18 and 22 mm): .... 24 kg.
Box dimensions: ............................................... 660 x 430 x 200 mm
Noise level: ....................................................... 100 dBA
Lp: .................................................................... 87 db
Vibration level: .................................................. 5,9 m/s
2. Machine components (See figure A)
1. Motor
2. Reverse lever
3. Handle
4. Bolt housing
5. Tripod
6. Former
7. Former hook
8. Former fastening shaft
9. Slide
10. Slide fastening bolt
11. Series bending scale
3. Capacity
Hard and soft Cu-Al DIN 1786 Øs 12 a 35 mm: 1,2 mm pared.
Hard and soft steel DIN 2391, DIN 2393, DIN 2394; Øs 12 a 28 mm x 2,5.
Steel DIN 2440 1/4" (14), 3/8" (18), 1/2 " (22), 3/4 " (28).
INOX AISI 304-316 espesor hasta 1,5 mm Øs 12 a 28 mm
Conduit: 16-20-25-32-35 mm
4. Preparation for start-up
1. Working position (See figure B.1)
The position shown in the sketch would be ideal for comfort and safety during the entire bending
process.
2. Working area (See figure B.2)
Before start, the bending area should be clear from any element that may interfere in the bending
process.
3. Use of extension cords The extension cable should as thick and short as possible. It should handle
more than 15 Amp., and never be more than 30 m. in length.
4. Check the state of the on/off switch
Make sure that the on/off switch unlocks automatically when not pressed.
5. Use of tripod (optional) (See figure B.3)
The sketch shows assembly and coupling of tripod to bending machine.
6. Device for series bending (See figure B.4)
The unit provides a device for setting the bending angle automatically from 0º to 180º. To operate,
8
1300003204.1.01.indd 8
100 V 50/60 Hz
110 V 50/60 Hz
2
ENGLISH
UA-10
07/04/16 14:50