Publicité
Les langues disponibles
Les langues disponibles
4) Push the crown in when done.
The second time zone time can alternatively be used to represent your
time on a 24-hour scale, if you prefer.
c h r o n o g r a p h
The watch provides a 4-hour split chronograph.
To start, press A (START/STOP). The center hand shows the seconds
with 0.2 second resolution, the linear hand shows the minutes (counting
up to thirty and repeating), and the lower hand shows the hours, up to
four before stopping automatically.
30
20
10
0
Chrono minutes = 40
Chrono seconds = 0
START/STOP
A
0
2 2
CROWN
B
SPLIT/RESET
Total chrono time = 1:40.00
(1 hour, 40 minutes, 0 seconds)
6
To stop, press A (START/STOP). All hands freeze.
To resume, press A (START/STOP), or to reset (zero) the chronograph,
press B (SPLIT/RESET).
When the chronograph is reset, all hands move to zero. After another
eight seconds, the watch resumes the normal display of the second time
zone time.
While the chronograph is running, press B (SPLIT/RESET) to take a split.
All hands freeze while the chronograph continues to run. Press B again
to resume display of the running chronograph elapsed time.
r o t a t i n g b e z e l
The rotating bezel can be used to measure an
elapsed time period.
To measure elapsed time, simply rotate the bezel
counter clockwise (to the left) until the zero mark
is aligned to the minute hand. From this moment
on, the minute hand in relation to the zero mark
on the bezel will indicate the total number of min-
utes that have elapsed.
For example, set the outer ring so that the zero
mark (triangle) is in line with the minute hand when you want to start
timing an event. The minute hand will then indicate on the outer ring the
elapsed time of that event.
7
Publicité
