Airzone EASYZONE AZCE6LITECB Guide D'installation Rapide page 39

Setting wireless device
- Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
open, you have 15 minutes to make the association. If that period of time expires, start the
process over again. Remember not to open more than one module at the same time, it may
alter the process. You can also open the channel association radio through the Blueface and
Think (see section System parameters).
IMPORTANT: not to open more than one radio channel at the same time, it may alter the
process.
- Start the radio channel search, to do so, press Airzone to start the search.
- Verify the range is correct (30% minimum) and confirm.
Zone address
Select the zone associated to the thermostat. All the zones have a corresponding control output. For example, the zone 1 will
control the actuator output 1.
Associated outputs
If necessary, the system allows you to associate more than one control output to a zone. It is possible to control multiple outputs
from the same thermostat.
Thermostat configuration
Select the operation of the thermostat:
- Master: Controls all the parameters of the installation.
- Zone: Controls all the parameters of the zone.
Other settings
Access the advanced settings menu (system address, stages of control, etc.) to change any other setting. Activate the basic
function if required (see Advanced Settings, zone parameters).
Blueface
ES
EN
FR
IT
PT
DE
39