Magmaweld RS 350M PRO Manuel D'utilisation page 25

RS 350 - 450 - 550 M / MW PRO
3.4 Selection and Replacement of Wire Feed Rollers
• Open the cover of the wire feed part. You will see the four-roller wire feed system.
3
5
4
4
2
6
6
5
Figure 11 : Wire Feed System
• Use wire feed rollers suitable for the material and diameter of
the welding wire you will use. Use V-grooved wire feed rollers for
steel and stainless steel, corrugated V-grooves for cored wires
and U corrugated ones for aluminum.
• If you need to replace the wire feed rollers, pull the pressure
roller lever toward your side and after lifting the pressure rollers,
remove the wire feed roller screws and remove the existing
rollers.
0.8 mm
Both sides of the rollers are marked according to the wire diameter used. Place the
rollers on the flange so that the wire diameter value you will use will be on the side
facing your side.
• After inserting the rollers, you will use, re-insert the screws and
lower the pressure rollers and lock the pressure roller lever onto
the rollers.
www.magmaweld.com
1- Engine
2- Euro Connector
3- Pressure Roller Handle
4- Pressure Rollers
1
5- Wire Feed Rollers
6- WF Roller Screws
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Figure 12 : Wire Feed Roller Removal
Figure 13 : Wire Feed Roller Placement
Operation 25
EN