PEERLESS SmartMount D-FPF-220 Installation Et Assemblage page 9

Mounting and Removing Flat Panel Screen
Hook adapter brackets (BB or CC) onto wall plate (AA). Then slowly swing screen in as shown. Turn safety/security
3
screws, using security allen wrench (FF), clockwise at least six times to prevent screen from being removed as shown in
detail 1 of figure 3.1.
Screen can be adjusted horizontally if desired as shown in figure 3.2.
NOTE: To lock the screen down, tighten safety/security screws to wall plate as shown in detail 1.
To remove screen from mount, loosen safety/security screws, swing screen away from mount, and lift screen off of mount.
WARNING
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the plasma television.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
A A
SAFETY/
SECURITY
SCREWS
BB
or
CC
DETAIL 1
BB or CC
A A
fig 3.1
9 of 27 ISSUED: 01-06-06 SHEET #: 202-9080-6 09-25-07
All other brand and product names are trademarks or registered trademarks of their respective owners.
fig 3.2
© 2007, Peerless Industries, Inc. All rights reserved.