Pfannenberg PY X-L-15 Utilisation page 7

Electrical connection:
PY X-L-15
Volume Control
AC version
Connection for
operation voltage
Tone Selector Switch
DC version
Connecting cables
**:
Combined beacon-sounders (PY X-LA-15) can be operated commonly or separately. Adjust S2 and S3 as shown in the table.
Option –SSM (Soft-Start-Module) (24V DC only):
- Limiting of the switch-on current peak to:
PY X-L(A)-15 -SSM:
- Connection of the operating voltage to the equipment starts at >7V
- Resistance for the line monitoring mounted.
Operating voltage range: 19.2 – 28.8V DC
Connection of a resistor for line monitoring: (dc versions only)
Only in case of separate operation of beacon and sounder:
Flash Frequency adjustment:
S1:
(Beacon)
*
Factory setting
Note: Depending on the adjusted flash frequency the appearance of the first flash after switching on may take up to 10 s.
085 501 995c
(PCB in base part)
PY X-LA-15
Tone Selector Switch
Operation voltage for sounder
Volume Control
Operation voltage
for sounder
: max. 4.25 A
Resistor for Line Monitoring (1K Ohm)
at the terminal for operating voltage.
Position of the resistor with parallel connection
of multiple beacons in the last unit
Remove unneeded resistors.
Operation voltage
for beacon
Operation voltage for beacon
** Combined beacon-sounders (PY X-LA-15) can be operated
commonly or separately. Adjust S2 and S3 as shown in the table.
: max. 4.25 A
PY X-LA-15
7
PY X-L-15
PCB
in lens
30396-004-1c