Technical Data; Circular Saw - Hilti SCW 18-A Mode D'emploi

4 Technical data

4.1 Circular saw

Rated voltage
Weight
Specified blade diameter
Blade disc thickness
Kerf width
Saw blade arbor size
Rated speed under no load
Maximum cutting depth
Bevel cutting angle
5 Operation
5.1 Removing the battery
1. Press the two release buttons and hold them in the pressed position.
2. Pull the battery out of the product to the rear.
5.2 Removing the saw blade
WARNING
Risk of burning injury. A hot accessory tool, clamping flange or clamping screw and the sharp edges
of the saw blade present hazards.
▶ Wear protective gloves when changing saw blades.
1. Pull the battery out of the product to the rear.
2. Insert the hex. socket wrench in the saw blade clamping screw.
3. Press the spindle lockbutton and hold it in this position.
4. Turn the saw blade clamping screw with the hex. socket wrench until the spindle lockbutton engages
fully.
5. Release the clamping screw by turning the hex. socket wrench in the direction of the direction-of-rotation
arrow.
6. Remove the clamping screw from the outer clamping flange.
7. Open the pivoting guard by swinging it to the side and then remove the saw blade.
Note
If necessary, the mounting flange can be removed for cleaning.
5.3 Fitting the saw blade
CAUTION
Risk of damage Unsuitable or incorrectly fitted saw blades may damage the saw.
▶ Only use blades which are suitable for this saw. Observe the direction-of-rotation arrow on the
saw blade.
10
3
4
SCW 18­A
21.6 V
8.6 lb
(3.9 kg)
6.3 in ... 6.5 in
(160 mm ... 165 mm)
0.02 in ... 0.06 in
(0.5 mm ... 1.5 mm)
0.06 in ... 0.1 in
(1.5 mm ... 2 mm)
0.8 in
(20 mm)
4,000 rpm
2.2 in
(57 mm)
0° ... 50°
7