Installation; Operation; Control Panel; Turn On - CombiSteel 7450.0315 Mode D'emploi

INSTALLATION

Note: If the unit has not been stored or move in an upright position, let it stand upright for approximately 12
hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the appliance in direct sunlight or damp areas.
3. When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
4. Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
of the appliance.
5. If necessary, adjust the screw feet of the appliance to make it level.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

OPERATION

CONTROL PANEL

The control panel is located below the doors on the front of the appliance.

TURN ON

1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
3. Turn the light switches On [I] or Off [O] as desired.
Note: The cooling light is illuminated when the appliance is chilling the interior cabinet.

SET THE OPERATING TEMPERATURE

1. Press the
2. Press the
required temperature.
3. Press the

MANUAL DEFROST

Back Bar Chillers feature an automatic defrost. However, should the appliance require an additional defrost
period press and hold the button for 6 seconds.
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
To stop the Defrost press and hold the
Note: If a manual defrost is started this resets the automatic defrost timer. During defrost periods the defrost
light is illuminated.
button. The display will flash.
or buttons to display the
button to store the temperature.
button for 6 seconds.
5