Applications; Conformity And Approval; Rack Mounting - IMG STAGELINE TXS-875 Mode D'emploi

2 . if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the units must be repaired by skilled
personnel .
•
For cleaning only use a dry, soft cloth, never use
chemicals or water .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other pur pos es than originally intended, if they
are not correctly connected or operated, or if
they are not repaired in an expert way .
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment .
3

Applications

In combination with a wireless microphone, the
multi frequency receiver TXS-875 makes up a
wireless audio transmission system which is ide-
ally suited for musicians and live performance on
stage . The wireless transmission of music or speech
to the audio system ensures the musician's freedom
of movement during the performance .
The True Diversity* receiver operates in the UHF
frequency range of 518 to 542 MHz . Within this
range, the audio transmission frequency can be
selected as desired (frequency spacing 125 kHz) .
The following transmitters from the product range
of IMG STAGELINE can be used:
– TXS-875HT (order no . 25 .5340)
Hand-held microphone with integrated multifre-
quency transmitter
– TXS-875HSE (order no . 25 .5330)
Multifrequency pocket transmitter, suitable for
connecting a headband microphone or a tie-clip
microphone
* True Diversity: The signal sent is received by two antennas
and amplified in two separate receiver sections . The signal
of the highest reception quality is then processed .

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the receiver TXS-875 complies with the directive
2014 / 53 / EU . The EU declaration of conformity is
available on the Internet:
www .img-stageline .com
Restrictions or requirements apply in the fol-
lowing countries:
CZ DE
IT LT
In the Federal Republic of Germany, the receiver
requires a frequency assignment (for which a
fee is charged) . In other countries, it is necessary
to apply for a corresponding approval . Prior to op-
erating the unit outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country . Links to the
national authorities can be found via the following
Internet address:
www .cept .org
t ECC
t Topics
t Other spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
t EFIS and National Frequency Tables

3.2 Rack mounting

To insert the receiver into a rack designed for units
with a width of 482 mm, use the holder RCB-870
(order no . 24 .2830) which is available as an ac-
cessory . The holder supports up to two receivers
and requires a height of 1 rack space (= 44 .5 mm) .
4 Connection
1) Insert the two antennas (6) provided into the
BNC antenna jacks ANT . 1 and ANT . 2 (11) and
put them in a vertical position .
Hint: To increase the transmission range and the inter-
ference resistance, it is possible to use the pair of an-
tenna signal amplifiers TXS-875B (order no . 15 .0840)
available as an accessory . The antenna jacks of the
receiver supply the amplifiers with power .
2) For connecting the subsequent unit (e . g . mixer)
the receiver is provided with two audio outputs:
– AF OUT . BAL . (10)
balanced XLR output for con necting a bal-
anced microphone input
EL FI FR
MT PL
9