Publicité
Les langues disponibles
Les langues disponibles
Turning off:
6.
When you reach the end of the groove, turn the unit out into the upper idle position with the main
switch still pressed (5).
7.
Release the main switch (5). Attention: The cutter blade will continue running for a brief period.
8.
Do not lift the unit off the floor until the blade has stopped rotating. Do not reach into the cutting area
of the unit.
After completing the work:
Clean the Parquet milling machine 18V and accessories thoroughly.
NOTE
Even though the unit has an integrated vacuum device, you still need to clean the
groove in between performing milling process and surface treatment.
Do not allow dust to build up in the work area.
Dust bag
Empty the dust bag (3) regularly. To do this,
remove the dust bag (3) plus dust bag holder
(24) from the ejector tube (7). Hold the dust
bag (3) over the disposal container and open
the zipper. Gently shake the dust bag (3) to
empty it.
Parallel stop
The parallel stop (14) is
located at a distance of 5.9 in.
from the center of the cutter
blade. Use the parallel stop to
cut grooves along existing
and/or other fixed edges.
14
14
39
Publicité
