WOLFF 163177 Traduction Du Mode D'emploi Original page 38

Turning on:
The unit must be in the idle
position when it is turned on.
Press the activation lock (6) so that it
1.
moves to the left/right and keep it held
down.
2. Press the main switch (5) and keep it
held down.
3. Release the activation lock (6).
4. Turn the unit in and move it into the
grooving position.
Grooving operation:
NOTE
An excessively high feed rate will reduce the
performance of the unit, impair the cutting
quality, and shorten the cutter blade service life.
WARNING
The cutter blade will continue running for a brief
period after you turn the unit off. When the
rotating cutter blade makes contact with the
material, there is a risk of recoil.
5. Move the Parquet milling machine 18V forward
along the seam in a straight line and at a
constant fee0rate.
We recommend guiding the Parquet milling machine
18V with both hands by placing one hand on the
handle (4) and the other hand on the cutter blade
housing or on the auxiliary handle (8). Do not
cover the air slots on the cover plate (21) with
your hand. If you are only able to guide the
Parquet milling machine 18V with one hand, place
one hand on the handle (4). Keep your other hand
clear of the cutting area.
38
Idle position
6
5
Grooving position
Feed direction