Storch ProDist compact plus Mode D'emploi page 97

Error signals/troubleshooting
Error Cause
code
203 Low battery
402 Computation
error
301 Temperature
too high
302 Temperature
too low
101 Laser reception
signal too weak
102 Reception
signal of laser
too strong
201 Ambient light is
too bright
401 Hardware error
Remedy
Change the batteries
Repeat the last measure-
ment
Cool the laser measuring
device
Warm up the laser measu-
ring device to the required
operating temperature
Use an alternative target
Reflections on the target
surface. Use an alternative
target. Reduce the distance
Use a measuring target in
a darker environment
Switch the device off and
back on. If the error mes-
sage is still shown, contact
our service hotline.
97
Original instruction