Storch ProDist compact plus Mode D'emploi page 90

Commissioning and settings
Switching the device on and off
- Button.
- Hold down the button to switch the device and
laser off.
The laser switches off automatically after 30 seconds; the
device after 3 minutes.
Delete values
- Briefly tap the button. This deletes previously
measured values from the device.
Determining the reference point (figs. of the points)
Measurement is set to the bottom edge of the housing. To
change this, press the reference point button and
select another reference measuring point (top, bottom, cor-
ner measurement). An audible tone confirms your selecti-
on.
After switching off the device, it reverts to the factory set-
ting and measures from the bottom edge of the device
again.
Original instruction
90