Override - Zehnder Alura LCD Manuel

Stage 2: selection of mode for each hour of the day
EN
The screen displays the first hour as "0 H" and the cursor at the bottom moves
to the current hour. The cursor showing the day stops blinking.
Pressing the MODE key for 5 seconds at this configuration stage will return you
to stage 1.
The following table lists the actions to be carried out in order to set your
programme.
Pressing
Key function
the key
+
Moves the current
hour to Comfort
mode ( ).
-
Moves the current
hour to Eco mode
( ).
Keeps the opera-
MODE
tion previously
specified for this
hour.
Stage 3: confirming the day
Continue in the same way until H = 23 is reached.
A brief press of one of the keys +, – or MODE will return you to the select day
screen.
Repeat the process from stage 1 to programme another day.
38
Screen display
The mode indicator
moves to Comfort and
goes to the next hour.
The mode indicator
moves to Eco and
goes to the next hour.
The mode indicator
does not change and
goes to the next hour.
AUTO mODE INDICATOr
AUTO mode allows your radiator to receive operating commands remotely from
a pilot wire programming base unit (not supplied with your appliance). The mode trans-
mitted will match the usual modes of your radiator
PROTECTION, ECO, COMFORT). It can also switch your radiator into one of two
additional modes (COMFORT -1°C and COMFORT -2°C).
Set the setpoint temperature on your radiator which corresponds to your requi-
rements in COMFORT mode using the – and + keys, then select AUTO mode by
pressing the MODE key repeatedly.
Then consult the instructions supplied with your programming base unit for
information on operating your radiator with it.

3.5 Override

In your radiator's programmed operating modes (P1, P2, P3 and PU, or AUTO
mode operated by an external base unit), you can locally override the operation of your
radiator by modifying the desired temperature level.
1st time
- or + pressed
2nd time
- or + pressed
The override will end the next time the operating mode changes at the radiator's
or programming base unit's request.
40008126 40008126
(STOP HEATING, FROST
If programme P1, P2, If AUTO mode
P3 or PU in progress in progress
● Instruction sent by
the base unit displayed.
● Modifies the
desired temperature.
● Symbol shown,
indicating override.
● Modifies the
desired temperature.
● Symbol shown,
indicating override.
EN
Using your appliance 39