Festool CTM 26 E Notice D'utilisation page 19

"Auto" switch position
Appliance socket [1-4] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
7 Settings
7.1 Adjusting the hose diameter
► Adjust the hose diameter adjuster [1-9] to
match the diameter of the connected hose.
The monitoring devices will measure the
air speed in the extractor hose correctly as
a result (see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket [1-4].
7.3 Connecting pneumatic tools
WARNING
Risk of injury
► Switch off the air tool.
Automatic on/off switch for air tools (CTM 36 E
LE, CTM 36 E LE AC, CTM 48 E LE, CTM 48 E LE
AC or accessories)
with compressed air module in module
slot [1-3]
Recommendation:
– Attachment of service unit VE (495886):
compressed air filtered and lubricated
– Use of IAS system with IAS connector
(454757) for Festool air tools
Requirement: tool with operating pressure of
6 bar!
7.4 Adjusting the suction power
► at the rotary knob [1-10].
7.5 Applying the brake
Folding out the black brake lever [1-15] pre­
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake lev­
er downwards until it latches into place. Push
the green lever [1-14] to release.
7.6 Temperature cut-out
To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.
► Switch off the mobile dust extractor and al­
low to cool for about 5 minutes.
If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.7 Changing the filter bag (SC FIS-CT
26/36/48)
Removing the filter bag [4]
► Open the locking clips [2-2] and remove the
top section of the machine[2-1].
► Remove the filter bag.
► Dispose of the used filter bag in accordance
with statutory regulations.
► Clean the dust container [2-3].
Inserting the filter bag [5]
► Insert a new filter bag (SC FIS-CT 26/36/48)
in the inlet port of the dust container and in­
terlock it. Important: be aware that the
locking engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
Make sure that the filter bag is not pinched
between the top and bottom sections.
7.8 Changing the disposal bag
Removing the disposal bag [6]
► Close off the extractor opening [1-2] using
the sealing plug [1-1].
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Close the disposal bag.
► Remove the disposal bag.
► Dispose of the used disposal bag in accord­
ance with statutory regulations.
► Clean the dust container [2-3].
Inserting the disposal bag [7]
► Insert a new disposal bag (ENS-CT26/36/48)
on the inlet nozzle of the container and lock
in position.
Important: The lateral openings on the dis­
posal bag must be positioned inside the
container. Make sure that the bolt engages.
► Place the disposal bag over the edge of the
container.
English
19