Table des Matières
Publicité
40
K0320 Issue No. 1
Set-up
Access code settings
The ACCESS CODE is programmable
by the customer. The following menus
are protected by this code;
ACCESS CODE
Calibration menu
(Electrical and pressure)
9410 is standard factory setting.
Leave the cursor at NONE at the
measure and source menu and press
# to open the set-up menu. Select
SYSTEM and press EXE. Select
ACCESS CODE and press EXE to
confirm. You are now in mode where
you can change the code. If applicable
the new code can be typed in and
confirmed by EXE. 0000 as code is
considered as no existing ACCESS
CODE.
NOTE: Registration of the
ACCESS CODE is essential.
Publicité
Table des Matières
