Table des Matières
Publicité
108
K0320 Issue No. 1
Programmable signal
converter
With this unique feature any input
signal (including the probe) can be
converted into any on the MCX-II
available output signals with full
galvanic isolation. Zero and span
settings for both input and output are
fully programmable.
Setting up a signal converter
Make all input and output selections
as you would do when you use input
and output functions separately in the
DIRECT output mode. When the
normal working screen is displayed
press # to open the set-up screen and
select convert. Fill out the input- and
output span and press EXE again to
proceed to the signal converter
working screen. Actual input and
output signals are now displayed.
NOTE: The signal converter
function can not be used in pulse
counting ranges.
Publicité
Table des Matières
