Tank Filter; Electrical Connection; Machine Start-Up; Turning Off The Machine - Wega EVDS io Mode D'emploi

6.4 Tank Filter

If the water hardness is more than 5°f, the use of a
BRITA filter (supplied) should be installed in the tank. Not
only does this filter reduce limescale build-up, but it also
eliminates any impurities and other substances such as
chlorine in the water.
Replace the filter of the tank according to the manu-
facturer's instructions.

6.5 Electrical connection

• Make sure that the information on the data plate
of the machine corresponds to the voltage of the
electrical mains;
• plug the machine into the electrical mains.
36

6.6 Machine start-up

Open the water mains tap.
Turn the machine on using the main switch of the
(11)
machine .
Before using the machine, wait for a short time (about
10 min.) until the gauge
ing pressure (1-1,2 bar).
LED level (12) warnings
10
Flashes The heating unit is being filled with water
Steady light Water filling OK
When the timeout device cuts in due to a block when filling the
heating unit with water, all the LEDs on all the push-button panels
will flash.
During the machine's heating-up phase (roughly 20 minutes), the
negative pressure valve will release steam for a few seconds until
the valve closes.

6.7 Turning off the machine

Turn off the machine via the machine's main switch.
(10)
indicates the correct work-
User manual
11
12