Adjustment Of Gas Flow - Magmaweld EXPERT Serie Manuel D'utilisation

EXPERT SERIES / EXPERT SERİSİ
The following effects will occur if the pressure adjustment screw is overtightened,
A: Suitable wire pressure and conduit dimensions. left loose or if the wrong wire feed roller is used.
B: The wire is distorted since the pressure lever is too tight.
C: The roller surface is deteriorated due to excessive pressure on the pressure lever.
D: The conduit length of the roller is small for the wire used. Wire form is distorted.
E: The conduit length of the roller is big for the wire used. The wire cannot be transmitted to the welding area.
Figure 10 : Pressure Setting and Roller Selection Mistakes

3.9 Adjustment of Gas Flow

Make the gas adjustment and gas test by lifting the wire feed roller pressure lever!
• Adjust the gas flow with the flow control valve.
• Practical gas flow rate (CO₂, Ar, mixture) is 10 times of
wire diameter.
For example, if the wire diameter is 0.9 mm, the gas
flow rate can be adjusted as 10 x 0.9 = 9 l / min.
• You can use the table on the side for more precise flow
adjustment.
• After adjusting the gas flow, lift the thrust bearing arm
and close the wire feed unit door.
www.magmaweld.com USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Mild Steel
and Flux Cored
Metal Cored
0.8 8 lt/min. 7 lt/min.
9 lt/min. 8 lt/min.
0.9
10 lt/min. 9 lt/min. 10 lt/min. 10 lt/min.
1.0
12 lt/min. 11 lt/min. 12 lt/min. 12 lt/min.
1.2
Operation 35
Stainless
Aluminium
Steel
8 lt/min. 8 lt/min.
9 lt/min. 9 lt/min.
EN