Yakima SuperJoe2 Mode D'emploi page 2

FITTING YOUR CAR...
When you see this icon, find
your vehicle in the Joe Fit
Sheet for frame measurement,
strap positions, and critical
notes about your fit.
DANGER
DO NOT INSTALL THIS
CARRIER ON A VEHICLE
LISTED AS "NO FIT".
ROTATE THE UPPER FRAME.
To move the frames, pull and turn both
red triggers on the outer hubs.
UPPER
FRAME
RED
TRIGGER
UNLISTED VEHICLES:
POSITION THE FRAMES. On a flat surface, move the frames apart.
Follow these guidelines to position your frames on your car.
UPPER FRAME
• With triggers out, adjust
upper frame until it rests
on the vehicle.
• The position is relative to
the lower frame and will
depend on vehicle shape.
CAUTION: Some vehicles have a spoiler. If
any part of the carrier contacts the spoiler,
do not use this product.
1033309B-2/24
OR
Rotate the trigger
until it remains
pulled out.
LOAD ARMS
\
LOWER SUPPORT FRAME
IF YOUR CAR IS NOT LISTED in the Joe Fit Sheet
or the Fit List, call 888-925-4621 in the USA and Canada,
or see your dealer.
UNLISTED VEHICLES:
IF YOUR CAR CANNOT BE FOUND (on the Joe Fit Sheet
or the Fit List, or through the dealer or Yakima) it is
"unlisted". Install the carrier as directed in these
instructions where this icon appears.
CAUTION: Although your carrier is covered by a warranty (see
final page), Yakima cannot warranty any installation onto any
vehicle that is not listed in the Yakima Fit List or Joe Fit Sheet.
POSITION THE FRAMES.
FIND YOUR MEASUREMENT
See FITTING YOUR CAR (above).
LOWER FRAME
• A common location is a well-supported license
plate depression, just above or below the numbers.
• Press the area firmly with your hand. If deformation
occurs, choose another location.
CAUTIONS:
• Do not place the lower frame on glass, plastic, or thin metal.
• Some SUV's, vans, and wagons have a large section of poorly
supported metal that will dent under weight.
IN THE FIT SHEET.
• You will need a
measuring tape.
• On a flat surface, move
the frames apart.
• WITH THE PADS FLAT,
MEASURE FROM THE
INSIDE EDGES OF THE
TUBES.