Publicité
Les langues disponibles
Les langues disponibles
6.
Unclip fill tube from container, but keep installed into
the fill valve. Submerge the fill tube into the appropriate
cleaning solution and pull the plunger in and out a
minimum of 5 times.
7.
Remove the fill tube. Submerge the fill valve and roller arm
and pull the plunger in and out a minimum of 5 times.
8.
Remove the roller arm. Submerge the head of the EZ-
Roller™ and the fill valve and pull the plunger in and out a
minimum of 5 times.
9.
Clean the remaining parts (caps, spacer and cover) by hand
using the appropriate cleaning solution.
10.
CLEANING THE FILL VALVE
A. Unscrew the locking cap (a) on the valve housing.
B. Remove the retainer disk (b) and the duckbill (c) from the
valve housing.
C. Clean these parts using the appropriate cleaning
solution. DO NOT allow parts to soak, as they could swell
and not seal properly.
D. Inspect the duckbill valve (c) for any tears or damage.
E. Lubricate the complete duckbill valve (c) with
petroleum jelly.
F. Allow all parts to dry before reassembly.
G. Replace the duckbill (c) and the retainer disk (b).
H. Screw the locking cap (a) back onto the valve housing.
6
7
8
9
10
a
b
c
5
EN
Publicité
