Niko 10-535-01 Mode D'emploi page 20

10-535-01
3. OPERATON AND USE
1
2
3
- If the installation has been carried out correctly and the system is connected to the
mains, the LED on the power supply module lights (10-801 or 10-802). The LED at the
external unit also lights, thereby lighting the vandalproof name plate. For programming,
see the user manual of the power supply (10-801 or 10-802).
- Briefly press function key 3
The door loudspeaker at the internal unit is activated and the green LED lights. The con-
nection is wound up by briefly pressing function key 3 or after 60s of activity.
- Press the door open key (function key 1)
supply, you can set the activation time of the lock between 0,8s and 8s (see user manual
power supply).
- Press the light switch key (function key 2)
power supply.
- If there is a call, the telephone rings once at the set tone (see 'Possible settings') and the
green LED on the internal unit lights. Briefly press function key 3 to communicate with your
visitor. If the visitor is hardly understandable due to background noises, just keep function
key 3 pressed while you are speaking. Let go of the function key to let your visitor speak.
The conversation is wound up by briefly pressing function key 3, automatically after 60s or
4s after opening the door. The green LED goes out if the conversation is wound up.
20
fig.4: front view and side view of the internal unit
to activate the door unit without the bell is rung.
to open the lock (fig.4). On the power
to control the light switch relay on the
A
B
EN