Niko 10-535-01 Mode D'emploi page 18

10-535-01
Installing the internal unit
Detach the front of the internal unit from the base with a screwdriver (fig.1a).
fig.1a: remove front of the internal unit
Mount the base of the internal unit on a wall at the desired height, using the installation
holes provided for this purpose (fig.2). If you wish to use the unit as a desk model, then
click the foot at the back of the base into the installation holes at the appropriate height
(fig.2, point A). Connect two wires of the cable to terminals a and b of the internal unit. If
over 60 internal units (10-535-01) are connected or several internal units must function in
parallel, you must also connect the P-wire.
wall fixing
fig.2: base of the internal unit for wall mounting or desk placement
Click the front of the internal unit onto the base again (fig.1b).
18
1
2
fig.1b: click front onto the base
A
cable transit
2
1
EN