Ribimex PRCGTHB36 Manuel D'instructions Et D'utilisation page 14

4.7- Installing/removing the blades (Fig. 5)
• This power tool equipped with 2 type of blades: 1) trimmer blade and 2) shear blade.
• WARNING! Remove the battery pack to avoid unintentional starting of the tool.
• Turn over the tool as illustrated in Fig. 5.
• Lift the cover lock with thumb.
• Slide the blade cover backward.
• Remove the blade cover.
• Remove and install the suitable blade into the tool.
• Make sure the blade is properly positioned in the tool, then restore the blade cover.
• Push the blade cover forward until it is locked in position.
4.8- Switch On/Off
• To start the tool, push the lock-off button (2), then pull the trigger switch (7).
• To stop the tool, release the trigger switch.
V. OPERATION
5.1- Intended use
This tool is intended for light trimming of shrubs and lawn edges in domestic use. This is not
intended for artisanal, commercial, professional and/or industrial use.
5.2- Operation
Before start
• Make sure the trigger lock works properly.
• Make sure the blade is sharp and properly installed.
• Make sure battery pack is sufficiently charged and properly installed.
• Check and clear the area for any hidden object, like rocks, wild animals.
• Remove thick twigs or stems (diameter larger than 8 mm) with pruner.
Operating the tool
• Depending on the application, stand or kneel in a stable position next to the cutting area.
• Firmly grasp the handle and start the tool.
• Start cutting in sweeping action (from side to side).
• If the balde hit a hard object, stop the tool. Remove the battery pack and inspect the blade
for damage.
Fig. 5a Fig. 5b
Page 14 / 25