Troubleshooting; Manufacturer's Assistance Center - Nilfisk 127 Manuel D'instructions

127 / 137
-

Troubleshooting

Fault
The exhauster fails to start
The rpm rate of the exhauster in-
creases
Dust leaks from the exhauster
Noisy suction motors
Electrostatic current on the exhauster
-

Manufacturer's assistance center

See appendix.
I
GB
F
D
E
C72
Causes
No power
Clogged primary filter
Clogged suction pipe
The filter is torn
Inadequate filter
Worn or broken carbons
Inexistent or inefficient grounding
12
Remedies
Check whether power is reaching the socket
Check whether the plug and cable are in a
good condition
Ask for assistance from an authorized mani-
facturer's technician
Shake the filter. Replace it if this is not suf-
ficient
Check the suction pipe and clean it
Change it for another of identical category
Change it for another of suitable category
and check
Demount and replace the motor carbons
Check all ground con-nections. Particularly
check the suction inlet fitting; lastly, the pipe
must be strictly antistatic
09/2008