General Safety Instructions; Getting Started - H-Tronic AL 800 Mode D'emploi

2. generAl sAFety instructions

When handling electrical items, the VDE regulations need to be followed.
Especially VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 0860.
– Before opening the device, make sure that it is disconnected from the mains.
– Tools may only be used on the device or components, if it is ensured, that the
device has been disconnected from the mains and that all electric charges, that
have been stored within the components, are discharged.
– Cables or leads connecting the device or connecting components within the
device should be examined thoroughly for faults in the insulation.
– If a fault in the cables of the device is found, the device should immediately be
removed from service until the defective cables have been replaced.
If the following manual does not fully describe function and safety precautions to a
layman, or if the technical appliance is not clear, or if it is unclear which external
devices may be attached and how to attach them, then it is vital to contact a
specialist for advice. Before mounting this device and connecting the accessories,
make sure, that this device is suitable for the intended use.
If there is any case of doubt or there are any questions, please contact specialists,
experts or the manufacturers of the modules and components. Please note, that
operating and connection errors are beyond our influence and that we cannot
maintain warranty or be made liable for damages occurring thereof.

3. getting stArted

The charger may only be connected and used in well-ventilated, dry interiors as
well as only in a small alternate current voltage of 230V/50 Hz. The position of
operation is optional. The permissible ambient temperature must not exceed 50°C
during operation. Please consider that operation and connection faults are beyond
our sphere of influence. Understandably, we cannot assume liability for defects
resulting from this.
The device may be used for the described purpose, if these operating instructions
are observed:
– Before each initial operation, check the charger as well as its leads for damages.
– Do not operate the device during frost or danger of frost to avoid the formation
of condensation water.
– Never connect your charger with the mains voltage if it is taken from a cold into
16 | General Safety Instructions