H-Tronic AL 800 Mode D'emploi page 17

a warm space. The condensation that is brought about may destroy or cause
an electric shock under unfavourable conditions. Let the device adjust down to
room temperature.
– Do not expose the device to rain or moisture to avoid a fire hazard and the
danger of an electric shock.
– Do not allow liquids of any kind to penetrate into the device.
– Never cover the ventilation slots or housing.
– Do not place the device near hot air sources such as radiators or similar.
– Never charge batteries in a boat or watercraft. Take the battery out of the boat
or watercraft before charging.
– In case of misuse (e.g. incorrect battery type or too long polarity reversal.) the
battery can be overcharged or damaged. In the worst case, the battery can
explode and can cause considerable damage.
– Keep the transmitters (mobile phones, transmitters for modelling etc.) away from
the charger since the incoming sender radiation can result in the failure of the
charging device or destruction of the charger and therefore the batteries.
– Handle the product carefully, thrusts, blows and dropping from even little height
will cause damage. A faulty device must no longer be used and must therefore
be disposed of.
– Do not expose the device to sunlight, strong dust formation, mechanic vibrations
or thrusts.
– Never put or lead the charging cable near to inflammable materials. The
charging cable may neither be kinked nor be led over sharp-edged parts.
– Ensure that no inflammable objects (wood, cloths, cleaning rags or similar) are
placed near the device. The mains or charger leads must not be modified,
extended or shortened. In addition, the leads must neither be bent, squashed
nor be guided through square-edged parts.
– Live cables or lines, which are connected to the device, must always be tested
before and after use for insulation faults or breakages.
– Immediately discontinue using the device, if an error is determined in the supply cable.
– If necessary, use an appropriate non-inflammable basis (e.g. a big, thick wall
tile or flagstone).
– Only use the device outside of the vehicle.
– Only start using the device outside of the vehicle. Ensure that a secure and stable
connection is established when connecting the battery charging clamps.
– Never use in the case of adverse ambient conditions. Adverse ambient conditions
Automatic Charger AL800
| 17