Comelit 41LED032 Manuel Technique page 7

TECHNICAL SPECIFICATIONS
• Loop Characteristics:
◊ Operating voltage .............................................................................................16 ÷ 32 VDC
◊ Max. current consumption. ...............................................................................< 2 mА @ 27 VDC
◊ Current consumption with PCB Status LED ON* .............................................5,4 mA
• Outputs Characteristics:
◊ Operating Voltage .............................................................................................12÷24 VDC
◊ Voltage for LEDs ...............................................................................................12 VDC
◊ Max current consumption. ................................................................................390 mA @ 24 VDC / 790 mA @ 12 VDC
• Automatic current limitation of the outputs:
◊ With Ri=0k ........................................................................................................15 mA
◊ With Ri=1k ........................................................................................................10 mA
◊ Max. length of connection cable for LEDs........................................................3 m
◊ Material/color (enclosure box) ..........................................................................ABS, grey
*Status LED for the state of module
• Dimensions [mm]
◊ Enclosure Box – 225x174x80 (LxHxP mm)
◊ PCB with mounted plug connectors – 162x130x35 (LxHxP mm)
◊ IP protection raring – IP43 (PCB Mounted into enclosure box)
ISOLATOR MODULE TECHNICAL SPECIFICATIONS
Vmax Maximum line voltage ................................................................................................32 V
Vnom Nominal line voltage ..................................................................................................28 V
Vmin Minimum line voltage .................................................................................................16 V
Vso max* Maximum voltage at which the device isolates .........................................................7,5 V
Vso min* Minimum voltage at which the device isolates ..........................................................5,9 V
Vsc max** Maximum voltage at which the device reconnects ...................................................6,7 V
Vsc min** Minimum voltage at which the device reconnects ....................................................5 V
Ic max Maximum rated continuous current with the switch closed ......................................0,7 A
Is max Maximum rated switching current (e.g. under short circuit) ......................................1,8 A
II max Maximum leakage current with the switch open (isolated state) ...............................16 mA
Zc max Maximum series impedance with the switch closed .................................................0,12 Ω @ 28 VDC;
Notes:
* Switches from closed to open
** Switches from open to closed
Note: The maximum cable length from the 41LED032 module to the LEDs in the connected mimic/repeater panel must be up to 3m.
PLUG CONNECTORS
The 41LED032 module is delivered with a set of plug connectors for quick wire installation, mounted to the
terminals on the PCB. To unplug a connector, just pull it up from the terminal. To plug it back, press down until
a click is heard.
0,15 Ω @ 16 VDC