Bosch GTA47W Consignes De Fonctionnement/Sécurité page 8

2610047964.qxp_GTA47W 6/29/17 10:57 AM Page 8
For Mounting Bosch 4100 Table Saw to
GTA47W Stand
1. Align the saw as shown in figure 8. Insert
one (1) hex head bolt U through one (1)
flat washer W and mounting hole in table
saw and through top tube bar F of the
stand.
2. Place one (1) flat washer W and securely
tighten with one lock nut V using two
10mm wrenches.
3. Repeat this procedure on the three
remaining mounting holes.
Fold Stand Upright
folding or unfolding the stand.
1. Slightly lift stand by the handle bar (Fig. 9).
2. Rotate release lever down to clear locking pins
(Fig. 9).
3. With both hands on the handle, pull up and
push forward on the stand (Fig. 10), until it
locks in the upright position (Fig. 11).
Lower Stand
1. Rotate the release lever, then pull back on
the stand slightly to disengage. Use foot to
pull out kick bar C, if necessary.
2. With both hands on the handle, pull back
and lower the stand until it locks in position.
Mounting Table Saw to Stand
Operating Instructions
Keep fingers clear of
hinge points when
U
W
F
W
V
FIG. 9
-8-
FIG. 8