Bosch GTA47W Consignes De Fonctionnement/Sécurité page 5

2610047964.qxp_GTA47W 6/29/17 10:57 AM Page 5
Step 1. Attach Upper and Lower Cross
Bars
1. Position lower cross bar B on a flat surface
as shown in figure 1.
2. Insert ends of lower cross bar B into the
upper cross bar A and align the holes of
both bars.
3. Insert four (4) phillips head screws N
through the holes of the upper and lower
cross bars. Using phillips screwdriver and
13mm wrench securely tighten with four
(4) M8 lock nuts M as shown.
Step 2. Attaching wheels
1. Mount the wheel I on the axle of the wheel
bar H (Fig. 2).
2. Place one (1) flat washer S on the
threaded end of the wheel axle. Thread
the lock nut T on the threaded end of the
wheel axle by hand (Fig. 2).
3. Using 24mm wrench tighten the lock T
until washer S does not move freely. Spin
the wheel to check tightness. If the wheel
doesn't turn freely, loosen the nut by 1/8 to
1/4 of a turn.
4. Repeat the same steps with the other
wheel bar G.
Step 3. Left and Right Linkage Bar/Wheel
Assemblies
1. Locate linkage bar D and left wheel bar H.
Note the "L" sticker on the wheel bar.
2. Place one (1) flat washer L on one (1) bolt
K. Insert the bolt, first, through the wheel
assembly H, then through the large spacer
Q, and then through the linkage bar D as
shown in figure 3.
3. Place another one (1) flat washer L on bolt
K. Using two 13mm wrenches tighten with
one (1) lock nut M until all the parts cannot
move freely. Then loosen the nut by 1/8 to
1/4 turn.
NOTE: Do not over-tighten lock nut – these
parts need to rotate for stand to operate
properly.
4. Repeat steps 1-3 using the other linkage
bar D and right wheel assembly
Assembly
FIG. 1
A
N
FIG. 2
K L
G.
-5-
A
M
B
T S
I
FIG. 3
Q D
L M
D G H
B
H
H
D