Publicité
Les langues disponibles
Les langues disponibles
2610047964.qxp_GTA47W 6/29/17 10:57 AM Page 7
Step 6. Attach Top Tube Bar
1. Locate the top tube bar F. Position holes in
end of top tube bar F with holes in upper
cross bar A as shown in figure 6. Make
sure the plastic bumpers E are pointing
down (Fig. 6a)!
2. Place one (1) flat washer L onto one (1)
hex head bolt J.
3. Insert bolt J through top tube bar F and
M
L
A
R
F
L
J
Step 7. Attach Linkage Bars
1. Align hole in upper linkage bar D with hole
in top tube bar F as shown in figure 7.
2. Place one (1) flat washer L onto one (1)
hex head bolt K.
3. Insert bolt K through linkage bar D and
place small spacer R on bolt between top
tube bar F and linkage bar D.
4. Insert bolt through top tube bar F, place
one (1) flat washer. Using two 13mm
wrenches tighten with one (1) lock nut M
until all the parts cannot move freely. Then
loosen the nut by 1/8 to 1/4 turn. Note: Do
not over-tighten lock nut - these parts need
to freely rotate for stand to operate
properly.
5. Repeat this procedure on opposite side.
FIG. 6
F
A
place small spacer R on bolt between top
tube bar F and upper cross bar A.
4. Insert bolt through upper cross bar A,
place one (1) flat washer L. Using two
13mm wrenches tighten with one (1) lock
nut M until all the parts can not move
freely. Then loosen the nut by 1/8 to 1/4
turn. Note: Do not over-tighten lock nut -
these parts need to freely rotate for stand
to operate properly.
5. Repeat this procedure on opposite side.
E
FIG. 7
M
F
K
-7-
FIG. 6a
E
F
A
L
F
R
D
L
D
Publicité
