Bosch GTA47W Consignes De Fonctionnement/Sécurité page 6

2610047964.qxp_GTA47W 6/29/17 10:57 AM Page 6
Step 4. Attach Linkage Bar/Wheel
Assemblies
1. Locate the right linkage bar D/wheel
assembly G and position on right side of
upper/lower cross bar assembly A as
shown in figure 4. Note: Wheel should
face outward from stand.
2. Place one (1) flat washer L onto one (1)
bolt J and insert through right wheel
assembly G.
3. Place another (1) flat washer L on bolt
between wheel
upper/lower cross bar assembly A.
4. Insert bolt through upper/lower cross bar
assembly A, place one (1) flat washer L.
Using two 13mm wrenches tighten with
one (1) lock nut M until all the parts can
not move freely. Then loosen the nut by
1/8 to 1/4 turn. Note: Do not over-tighten
lock nut - these parts need to freely rotate
for stand to operate properly.
5. Repeat procedure on left side.
Step 5. Attach Kick Bar
1. Locate the kick bar C and position it
between the left and right wheel
assemblies H and G as shown in figure 5.
2. Place one (1) star washer P onto one (1)
hex head bolt O. Insert bolt through the
wheel assembly and thread it into the kick
bar C and, using 13mm wrench, tighten
down to the point when the star washer P
cannot move freely. Then tighten securely
by turning bolt an additional 3/4 to 1 full
turn.
3. Repeat this procedure on opposite side.
assembly G and
-6-
FIG. 4
J
G A D
FIG. 5
H
C
G
M
L
A
L
G
L
C
P
G
O