SEFRAM 7805B Manuel D'utilisation page 28

With the Save key you will be able to store tables of parameters and measurements.
1 – SAVE OF THE TABLES OF PARAMETERS
Please enter first the parameters screen
And then press the Save key
The instrument gives a default file name to the numerical table of parameters: « PLACE:
PLACExxx » that can be changed.
In order to find out it faster, the table can be saved for example under the name
of the satellite.
Numerical tables of parameters can also be made with the TR7836 transfer
software and be downloaded in the instrument.
2 – SAVE OF MEASUREMENTS
Please enter first a Measure screen
And press the Save key
The instrument gives a default file name to the measure: « MEASURE: MEMOxxxx » that can be
changed.
The save of measurements is not possible when working with the check sat mode.
Both parameters and results of measures are memorized allowing you to recall these data after.
If necessary, you can later transfer the saved measures to your PC with the
TR7836 transfer software and create some measurement reports on it.
3 – RECALL OF THE TABLES OF PARAMETERS AND MEASURES
You need to press the Configuration key
– 7805B –
SAVE
.
.
.
.
. (Refer to « Configuration »)
p. 28