Overview - XciteRC X-pert Charger X50 Mode D'emploi

Warnings and safety notes · Overview
• WARNING: do not use defective or damaged batteries or rechargeable batteries – fire hazard!
Risk of chemical burns on contact with skin, use protective gloves!
• WARNING: Do not attempt to recharge non-rechargeable batteries in a charger - fire or explosion
hazard!
• WARNING: Allow the cells to cool down before charging, never charge hot cells - fire or explosion
hazard!
• WARNING: Remove the batteries from the device before charging. Never recharge batteries that
are permanently installed in a device - fire or explosion hazard!
• Immediately remove used batteries from the devices.
• NOTE: note the specified storage voltage for lithium batteries. Is a completely full or empty lithium
battery time stored for a longer time, it can be damaged.
• NOTE: NiMH batteries must be checked at least every 3 months and, if necessary, recharged, other-
wise because of the typic self-discharge they may get deep discharged and damaged! Therefore, better
use so-called RTU batteries with a very low self-discharge.
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use,
therefore, the warranty is excluded due to incorrect charging or discharging.

Overview

Fan
100 - 240 V AC
11 - 18 V DC
STOP
WARNING: Use only batteries with XH balancer plugs. Never try to connect other plug types with the
charger! The plug or charger may damage or worse, the battery catches fire or explodes! If necces-
esy, use a suitable adapter cable.
X-pert Charger X50
-
+
LCD screen
Balancer connector
Output
START
-
+
EN
15