Overview; Using The Charger For The Fi Rst Time - XciteRC 52100000 Micro-LiPo-Charger 2-3S Mode D'emploi

• WARNING: do not use outdoors. Protect the charger from damp, rain and heat - fi re hazard!
• WARNING: Connect the charger to a suitable and adequately dimensioned power supply - fi re
EN
hazard!
• WARNING: the charger and the battery to be charged should be set up on a heat-resistant, non-
infl ammable and non-conductive surface before use. Provide good ventilation, do not cover the charger.
The charging process must be supervised by an adult - fi re hazard!
• Keep all infl ammable and volatile materials well away from the charging area.
• Disconnect the charger from the mains after use.
• WARNING: do not expose batteries / rechargeable batteries to heat or throw into fi re - fi re or
explosion hazard!
• WARNING: insert batteries / rechargeable batteries with the correct polarity, no short-circuiting -
fi re or explosion hazard!
• WARNING: do not use defective or damaged batteries or rechargeable batteries – fi re hazard! Risk of
chemical burns on contact with skin, use protective gloves!
• WARNING: Do not attempt to recharge non-rechargeable batteries in a charger - fi re or explosion
hazard!
• Remove the rechargeable batteries from the device before charging.
• Charging may take place only with a suitable charger for the type of battery on a fi reproof surface and
under constant adult supervision – fi re hazard!
• Immediately remove used batteries from the devices.
• NOTE: note the specifi ed storage voltage for lithium batteries. Is a completely full or empty lithium
battery time stored for a longer time, it can be damaged.
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use,
therefore, the warranty is excluded due to incorrect charging or discharging.

Overview

Mains supply
100 - 240 V AC
Status LED's
Using the charger for the fi rst time
Connect the included power cord to the charger, then connect the charger to an electrical outlet with 100-
240 V AC. The three LEDs on the top now light green, interrupted by short red fl ashes. The charger is now
ready for operation.
WARNING: the Micro-LiPo-Charger is only suitable for LiPo or Li-Io batteries with a nominal voltage of
7.4 or 11.1 V (respectively 8.4 or 12.6 V end-of-charge voltage). Before you start charging, make sure that
the battery to be charged is the correct type - do not attempt to charge batteries with different number of
cells or even other battery types - fi re or explosion hazard!
Generally, lithium batteries can be charged up to 1C rate, ie. 1C charging rate = capacity charging current.
For example with a capacity of 1500 mAh is the corresponding 1C charging current: 1500 mA (1.5 A).
WARNING: the maximum charging current is 1A. According to this, for batteries with a capacity lower
10
Warnings and safety notes · Overview
3S balancer-
connector XH
2S balancer-
connector XH
Micro-Lipo-Charger