Renson CAMARGUE SKYE 2.0 Manuel D'utilisation page 126

Starting the Renson Skye app (continue)
1. After previous registration, you can now log in with your account. When logging in, make sure you are connected to the same
network your Skye is connected to (so via WiFi, not via 4G).
2. Now you can start configuring your terrace cover. Press "Start configuration".
3. Choose the Skye you wish to connect to.
4. Enter the user code and press «next».
This code can be found in the user manual (guarantee certificate) or during installation also visible on the Skye control unit.
5. The configuration of your Skye is completed. Press «Finish installation».
Note: steps 3 to 6 must be repeated for each roof part.
6. The app starts and the connected roof parts are shown. From now on you can control your Skye roof.
For your information: You can now control the roof of your Skye from anywhere as long as your device is connected to the internet.
The device you use to control the Skye may be connected to a different network than the one the Skye is connected to.
Operation is possible as long as your device and the Skye have internet access.
➊
Creating healty spaces
Log in
Email Address*
Password*
Forgot your password?
LOG IN
126
Register
➍
Skye2 (200427S0002)
Enter user code
Enter user code
CONTINUE
➋
Creating healty spaces
Let's start!
Con gure your components in order to
use them via the app.
START CONFIGURATION
➎
Con guration
Device is already con gured.
Skye 2_S0002
Maalbeekstraat 10
8790 Waregem
Review con guration
FINISH SETUP
➌
Device(s) found
Select the device you want to connect with.
Skye2 (200427S0002)
CANCEL
➏
Home
Hello
1°C, snow
OPEN
Roof
CLOSE
1 Roof