Renson CAMARGUE SKYE 2.0 Manuel D'utilisation page 119

Temperature
∫ The covering tolerates normal ambient
temperatures (-18°C to +60°C).
∫ Do not completely close the blades of
the covering with frost.
Waterproof
∫ The bladed roof of your covering is wa-
terproof.
∫ In order to ensure good water resist-
ance, your covering must be installed
according to the installation instruc-
tions. Damage caused by rainfall due
to poor installation is not covered by
the general warranty.
∫ Condensation may form at the bottom
of the blades.
∫ A covering is an open 'outdoor' con-
struction, not comparable to a (ther-
mally) closed, waterproof and wind-
proof conservatory. Furniture, floor, etc.
must be suitable for outdoor use.
∫ The set-up, location, finishing, design,
installation, etc. as well as extreme and
exceptional weather conditions can
have an (unforeseen) influence on the
watertightness.
∫ Drop formation can occur in the frame
and columns. If in doubt as to whether
the drop formation is abnormal (not in-
herent to the product), please contact
the installer. They can assess whether
or not it is a defect/error.
∫ Water splashes on the gutters during
heavy rainfall are minimized due to the
perforated louvres (panels) but can
never be completely avoided.
∫ DO NOT hose down with high pres-
sure.
USE
Snow
∫ The bladed roof provides limited pro-
tection against snow load. This de-
pends on the dimensions of the sys-
tem.
∫ In case of heavy snowfall, the roof must
be open.
Wind
BLADES
∫ With blades (blades in stack or ful-
ly closed position), the covering can
handle wind speeds of 120 km/h in
stacked condition. For stand-alone
coverings, the warranty for wind loads
of up to 120 km/h only applies to cast
or reinforced mounting bases.
∫ The blades can be operated at wind
speeds of up to 50 km/h and must be
stacked (or fully closed) at wind speeds
of > 50 km/h.
VERTICAL SUNSCREENS
∫ We recommend that the Fixscreens
should only be lowered in windless
surroundings (max. 15 km/h). Upward,
you can operate the sun protection
fabric at wind speeds of up to 30 km/h.
∫ All screens must be erected at wind
speeds exceeding 60 km/h.
∫ For wind protection of your vertical
screens, an optional wind sensor is
needed. 1 sensor for all screens.
Obstacles
∫ When tilting and sliding the blades and
when rolling the sun protection fabric
up and down, there must be no ob-
stacles preventing this movement, e.g.
branches, cables, etc.
Electrical control
∫ Stop the movement immediately if the
motor makes an abnormal noise. Con-
sult the installer if you cannot find the
cause yourself.
∫ If the final adjustment of the motor is
no longer adequate (e.g. the roof does
not close completely), consult your in-
staller.
∫ See also specific electrical regulations
(page 121).
EN
119