Ama TAG300TD Notice D'emploi page 44

GB
If the mini tracked dumper will not be used for
a period longer than 30 days, follow the steps
below to prepare your unit for storage.
1. Drain the fuel tank completely. Stored fuel
containing ethanol or MTBE can start to go
stale in 30 days. Stale fuel has high gum
content and can clog the carburetor and
restrict fuel flow.
2. Start the engine and allow it to run until
it stops. This ensures no fuel is left in the
carburetor. Run the engine until it stops.
This helps prevent gum deposits from
forming inside the carburetor and possible
engine damage.
While the engine is still warm, drain the oil
3.
from the engine. Refill with fresh oil of the
grade recommended in the Engine Manual.
Problem
Engine fails to
start.
Engine runs
erratically.
Engine
overheats.
One of the two
tracks is blocked.
Machine does
not move while
engine is running.
MINI TRACKED DUMPER
18
STORAGE
TROUBLE SHOOTING
Cause
1. Spark plug wire disconnected.
2. Out of fuel or stale fuel.
3. Choke not in open position.
4. Blocked fuel line.
5. Fouled spark plug.
6. Engine flooding.
1. Spark plug wire loose.
2. Unit running on CHOKE.
3. Blocked fuel line or stale fuel.
4. Vent plugged.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
7. Improper carburetor adjustment.
1. Engine oil level low.
2. Dirty air cleaner.
3. Air flow restricted.
4. Carburetor not adjusted properly.
Foreign bodies have worked their way
between the track and the frame.
1. Gear is not properly selected.
2. Driving tracks not tight enough.
4. Use clean cloths to clean off the outside of
the machine and to keep the air vents free
of obstructions.
Do not use strong detergents or
petroleum based cleaners when
cleaning plastic parts. Chemicals
can damage plastics.
5. Inspect for any loose or damaged parts.
Repair or replace damaged parts and
tighten loose screws, nuts or bolts.
Store your unit on flat ground in a clean,
6.
dry building that has good ventilation.
Do not store the machine with fuel
in a non-ventilated area where fuel
fumes may reach flame, sparks,
pilot lights or any ignition sources.
Remedy
1. Attach spark plug wire securely to
spark plug.
2. Fill with clean, fresh gasoline.
3. Throttle must be positioned at choke
for a cold start.
4. Clean the fuel line.
5. Clean, adjust gap, or replace.
6. Wait a few minutes to restart, but do
not prime.
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF.
3. Clean fuel line. Fill tank with clean,
fresh gasoline.
4. Clear vent.
5. Drain fuel tank. Refill with fresh fuel.
6. Clean or replace air cleaner.
7. Refer to Engine Manual.
1. Fill crankcase with proper oil.
2. Clean air cleaner.
3. Remove housing and clean.
4. Refer to Engine Manual.
Remove the foreign body.
1. Ensure gear lever is not in-between
two different gears.
2. Tighten driving tracks.