Publicité
Les langues disponibles
Les langues disponibles
Gearbox Lubrication
GB
The gearbox is pre-lubricated and sealed at the
factory. Unless there is evidence of leakage or
service has been performed on the gearbox, no
additional lubricate should be required until 50
hours use.
After first 50 hours use, change all the gear oil.
Capacity is 1.5L.
For future use, check the oil level after every
50 hours of use. If you remove the oil level plug
and no oil flows out, please add oil and then
screw the oil level plug.
G e a r o i l G L - 5 o r G L - 6 , S A E 8 0 W - 9 0 i s
recommended. Do not use synthetic oil.
When replacing gear oil, the engine must be
stopped and still warm. Unscrew the filter cap
and the drain plug. When oil is drained, replace
the drain plug, fill up with fresh oil, and then
replace the filter cap.
Oil Outlet
Tightening Tracks
With u se , t rac ks te n d t o l oo se n . W hen
operating with loose tracks, they tend to slip
over the driving wheel causing it to jump its
housing, thus damaging wear to the housing.
To check track tightness, proceed as follows.
1.
Set the machine on a flat surface with
compact ground, or on asphalt or pavement.
2.
Lift the machine and set it on blocks or
supports rated for the weight of the machine
so that the tracks are approximately 4" off
the ground.
MINI TRACKED DUMPER
16
Oil Filler
3.
Measure the track midline vs. the horizontal
line. The reading must not be more than
10cm~15cm.
If the distance is greater, proceed as follows.
1.
Use the tipping handle to tip the hopper
and set it on blocks or supports rated for
the weight of the box.
2.
Loosen locknut A.
3.
Tighten bolt B until the correct tightness is
restored.
4.
Secure bolt B by tightening locknut A
thoroughly.
Return the hopper to its original position.
5.
Jam Nut
A
A
B
Adjusting Bolt
B
Publicité
