HOLZMANN MASCHINEN WB162L Mode D'emploi page 14

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
12. Once the vise screw and washer are removed,
slide the vise into the three holes on the side
of the worktop. Use the vise handle to thread
in the vise all the way and install the vise
screw and washer (No.12).
13. Use the screws (No.22) to fasten the drawer
handles (No.21) to the drawer front panels
(No.16)
14. Fasten the drawer panel (No.18) and the
drawer side panel (No.19) to the drawer front
panel.
15. Fasten the drawer back panel tot he ends of
the two side panels. Then slide the drawer
bottom (No.22) into the grooves along the
insides of the side panels and fix the drawer
bottom with 3 screws.
16. Fasten drawer bottom to drawer back panel.
Once drawers are fully assembled, verify that
the inside tracks along the divider are pushed
forward.
17. Put in the drawers.
18. Finally, put the bench dogs (No. 11) in the
holes of the worktop and the wood pegs (No.
10) in the holes of the right frame side.
ASSEMBLY
14
WB 162 L