HOLZMANN MASCHINEN WB162L Mode D'emploi page 13

Now you can set the assembled frame right-side up.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
5. Place the worktop (No.1) face down on a
smooth, padded surface. Note: When setting
down the assembled legs onto the worktop,
verify both legs and worktop are facing the
correct direction.
(Stickers help).
6. Set the divider incl. Drawer runners (No.14)
into place by inserting the tabs at the end of
the divider into the holes at the centre of the
worktop's underside.
Verify that divider and worktop face the same
direction
7. Use the screws (No.13) to fasten the divider
to the middle of the worktop's underside.
Note: There are no pilot holes available for this
step.
8. Fix the legs (No.4) with screw (No.6) on the
worktop's underside.
9. Additionally fix the legs (No.4) with screw
(No.13) on the worktop's underside. Note:
There are no pilot holes available for this
step.
10. Set the lower support (No.15) across the top
of the divider and against the sides of the
legs. Then use screws (No.6) to fasten each
end of the lower support to the sides of the
legs.
11. Once the ends of the lower support have been
fastened to the legs, use the screws (No.6) to
fasten the middle of the lower support to the
top of the divider.
ASSEMBLY
13
WB 162 L