Oki LD670 Mode D'emploi page 65

Plain paper (including full-sheet label paper)
L1: Length from the vertical reference position to the next reference position
L2: Length of the detection area for the vertical reference position
L3: Length from the vertical reference position to the start position
L4: Length from the vertical reference position to the cutting position
L5: Print area length
L6: Length from the left edge of the paper to the left end of the print area
L7: Print area width
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by
L6
: Not determined
: Not determined
: Not determined
: Not determined
: Not determined
: 1.0 mm (for a paper width of 83 mm)
: 4.0 mm (for a paper width of 80 mm)
: 3.0 mm (for other paper widths)
: 80.0 mm (for a paper width of 83 mm)
(Paper width - L6 x 2) mm (for other paper widths)
the driver or utility.
Ｌ７
Print Area
63