Oki LD670 Mode D'emploi page 64

Die-cut label paper
L1: Length from the vertical reference position to the next reference position
L2: Length of the detection area for the vertical reference position
L3: Length from the vertical reference position to the start position
L4: Length from the vertical reference position to the cutting position
L5: Print area length
L6: Length from the left edge of the paper to the left end of the print area
L7: Print area width
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by the driver or utility.
Note: If the paper length (L1) of the loaded roll paper differs by 10% or
more from the initially set paper length (L1) or that set upon
automatic recognition, an error occurs because the type of loaded
roll paper is considered illegal.
L3
L4
Print Area
L6
: Automatically detected
: Automatically detected
: (L2/2 + 1.5) mm
: 0.0 mm
: (L1 - L3 x 2) mm
: 5.0 mm
: (Paper width setting - L6 x 2) mm
Ｌ5
L2
Ｌ７
62
Base Position
Ｌ１