Publicité
Les langues disponibles
Les langues disponibles
3
1. Remove the ground speed control levers and mounting
hardware from the handle bar box.
2. Install the ground speed control levers (A & B) onto the
control lever base using the hardware (E) supplied in the
box. Prior to tightening the bolts, align the handles with
each other.
Install the Seat
This procedure is only necessary if the seat is not factory-
installed on your unit.
Some models are equipped with two sets of holes in the
seat plate that the seat can be installed in. Use the forward
set of holes to position the operator closer to the front of the
machine and the rear set of holes to position the operator
towards the rear of the machine. Determining what holes
to use is based on the preferred operating position of the
operator.
1. Unpack the seat.
2. Install the seat (A, Figure 4) onto the seat mount plate (B)
and secure with the 5/16 nylock flange nuts (C).
4
3. Connect the wire harness (D) to the seat switch (E) that is
located in the bottom of the seat.
Rigid Roll Bar Installation
If you are installing a rigid roll bar onto your unit follow these
instructions:
Install the Roll Bar to the Unit
The roll bar (A, Figure 5) is installed in roll bar pockets which
are part of the main frame of the unit and are located behind
the seat and in front of the engine on both sides of the unit.
5
The roll bar has safety decals installed on one side of the roll
bar and when the roll bar is installed on the unit the decals
5
Publicité
