Reinstall The Refrigerator; Replacement Parts - Norcold 323 Manuel Du Propriétaire

Masquer les pouces Voir aussi pour 323:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Remove the AC power cord from the receptacle.
- Remove the DC fuse or remove the DC wiring from the battery or the converter of the vehicle.
- Mark the DC wires so you can put them back in the correct location.
- Remove the DC wires from the refrigerator.
4. Remove the screws which fasten the rear of the refrigerator to the floor.
5. Remove the screws which fasten the refrigerator to the wall.
6. Remove the refrigerator.

Reinstall the Refrigerator

NOTICE
A dealer or Norcold authorized service center must do this procedure.
Make sure the seal strips are not broken, are completely around the refrigerator mounting flanges, and
!
WARNING
are between the refrigerator mounting flanges and the wall of the enclosure. If the seal is not complete,
exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, or in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Put the screws though the mounting flanges and into the wall.
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on the
!
CAUTION
refrigerator, be careful and wear cut resistant gloves.
3. Open the lower intake vent and put the screws through refrigerator and into the floor.
To avoid possible propane gas leaks, always use two wrenches to tighten or loosen the gas supply line
!
connections.
WARNING
4. Attach the gas supply line to the 3/8 inch male flare fitting of the refrigerator.
5. Open the valve at the propane gas tank(s).
Do not allow the leak detecting solution to touch the electrical components. Many liquids are electrically
!
conductive and can cause a shock hazard, electrical shorts, and in some cases fire.
WARNING
6. Examine the gas supply line for leaks.
7. Connect the DC wiring to the refrigerator:
- Install the DC fuse and connect the DC wiring to the battery or the converter.
- Connect the DC wires from the refrigerator.
8. Connect the AC power cord to the receptacle.

Replacement Parts

You may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.
Owner's Manual 13

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

N260.3

Table des Matières