Remove The Refrigerator; Reinstall The Refrigerator - Norcold N61X Manuel De L'utilisateur

Remove the Refrigerator

Your dealer or Norcold authorized service center must do this
procedure.
!
CAUTION:
The rear of the refrigerator has sharp edges
and corners. To prevent cuts or abrasions when working
on the refrigerator, be careful and wear cut resistant
gloves.
1. Close the valve at the propane gas tank(s).
!
WARNING:
To avoid possible propane gas leaks, always
use two wrenches to loosen and tighten the gas supply
line connections.
2. Remove the AC power cord(s) from the receptacle.
3. Remove the DC wiring from the refrigerator:
- Put a mark on the DC wires so you can put them back in the
correct location.
- Remove the DC fuse or remove the DC wiring from the
battery or the converter.
- Remove the DC wires from the refrigerator.
4. Open the lower intake vent and remove the gas supply line
from the bulkhead fitting of the refrigerator.
5. Remove the plastic plugs from the mounting flanges of the
refrigerator.
6. Remove the screws from the mounting flange at the rear of
the refrigerator.
7. Remove the screws from the upper and lower mounting
flanges on the front of the refrigerator.
8. Remove the refrigerator from the opening.

Reinstall the Refrigerator

Your dealer or Norcold authorized service center must do this
procedure.
!
WARNING:
Make sure the combustion seal is not
broken, is completely around the refrigerator mounting
flanges, and is between the mounting flanges and the wall
of the enclosure. If the combustion seal is not complete,
exhaust fumes can be present in the living area of the
vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Install the screws in the upper and then the lower mounting
flanges on the front of the refrigerator.
3. Install the screws in the mounting flange at the rear of the
refrigerator.
4. Put the plastic plugs into the mounting flanges of the
refrigerator.
!
WARNING:
To avoid possible propane gas leaks, always
use two wrenches to loosen and tighten the gas supply
line connections.
5. Attach the gas supply line to the bulkhead fitting of the
refrigerator.
6. Open the valve at the propane gas tank(s).
!
WARNING:
Do not allow the leak checking solution
to touch the electrical components. Many liquids are
electrically conductive and can cause electrical shorts and
in some cases, fire.
7. Examine the gas supply line for leaks.
8. Connect the DC wiring to the refrigerator:
- Connect the DC wires to the refrigerator.
- Install the DC fuse or connect the DC wiring to the battery or
the converter.
9. Connect the black AC power cord to the receptacle.
Owner's Manual 9